Tag: weight

Leonardo AW169 capabilities to grow with increased Gross Weight and 11 seat configuration

October 30, 2023 / WIL BALDWIN

Rome, Italy, October 30, 2023 – The Leonardo S.p.A. (OTC: FINMY) AW169 light intermediate twin engine helicopter’s operational capabilities and range of options will grow further with the launch of a 5,100 kg (11,243 lb) IGW kit and an 11-seater configuration fully compliant with the IOGP (International Association of Oil & Gas Producers) Report 690. Both will be made available for the aircraft version with skid landing gear.

Compared to the standard 4,800 kg (10582 lb) Maximum Take-off Weight, the extra 300 kg (661 lb) available with the 5,100 kg IGW kit allows the embarkation of three more passengers or the addition of fuel for approximately one hour of operations. Existing operators of the type’s version with skids will be able to retrofit the 5,100 kg IGW kit to enhance their aircraft’s capabilities.

As an additional option, the 11-seater configuration, fully compliant with the IOGP Report 690 (Offshore Helicopter Recommended Practices), will introduce a new modular fuel tank system and two additional Type IV emergency exits in the cabin, increasing the total number from four to six. The 11 seats configuration will be available for the skid-fitted version in combination with the 5,100 kg IGW kit. This solution will allow the type to satisfy even more demanding offshore transport requirements in terms of payload, range, and compliance with IOGP latest standards.

This configuration will allow a radius of action of up to 75 nm with 11 passengers, therefore offering capabilities typically achievable with types with a MTOW exceeding 5.5 tons (intermediate class) at a light intermediate class cost of operations as well as granting latest safety standards compared with legacy helicopters. It will also deliver greater sustainability versus ageing types in the relevant weight category thanks to a more efficient powerplant, advanced navigation, modern support and maintenance approach, among other solutions. The Certification of the IGW increase is expected in 2024 while the 11-seater configuration with new modular fuel tank is planned for certification in 2026.

These latest operational capabilities will add to the EASA (European Aviation Safety Agency) certifications of the skid undercarriage and unique IFR, single pilot, Advanced Search and Rescue (SAR) Modes, both achieved in late 2022. With the skid configuration certification, the AW169 became the only modern CS29-certified aircraft able to offer all undercarriage solutions, further demonstrating the versatility by design of the type. The AW169 is also the only helicopter in its weight category that features Advanced SAR Modes. The performance increase packages previously developed had already enhanced engine performance and capabilities, transmission ratings and available payload through engine software updates and aircraft aerodynamics modifications, making the type the helicopter with the best power-to-weight ratio in its class.

Forward-Looking Statements

This press release contains forward-looking statements within the meaning of the Private Securities Litigation Reform Act of 1995, including expected delivery dates. Such statements are based on current expectations and projections about our future results, prospects and opportunities and are not guarantees of future performance. Such statements will not be updated unless required by law. Actual results and performance may differ materially from those expressed or forecasted in forward-looking statements due to a number of factors, including those discussed in our filings with the Securities and Exchange Commission.

Saab receives Carl-Gustaf order from Japan

October 20, 2023 / WIL BALDWIN

SAAB AB (Stockholm: SAABb) has received an order from the Japan Self-Defense Forces, JGSDF, for the supply of the man-portable, multi-role weapon system Carl-Gustaf^®. The order includes over 300 systems and deliveries will take place in 2025.

Carl-Gustaf is a man-portable multi-role weapon system that provides high tactical flexibility through its wide range of ammunition types. It is extremely light-weight, and has established itself as the main shoulder launched weapon in many countries. It has been in use with the Japan Self-Defense Forces since 1979.

Proven to deliver results on the battlefield, Carl-Gustaf provides the effectiveness soldiers need. The wide range of ammunition types for Carl-Gustaf makes it flexible and able to handle any situation, whether it is to defeat an armoured vehicle or structure, or illuminating the battlefield during night operations.

The Carl-Gustaf system has a long and distinguished history, which stretches back to 1948, and is now supplied to more than 40 countries around the world.

Textron Aviation receives order for five Beechcraft King Air turboprops in support of Kingdom of Saudi Arabia

July 12, 2023 / WIL BALDWIN

Wichita, Kansas (July, 11, 2023) – Textron Aviation (NYSE: TXT) today announced it has been awarded a contract by AvMet International LLC (AvMet), based in Fargo, North Dakota, for one Beechcraft King Air 360CHW (cargo door, heavy weight) and four Beechcraft King Air 260 aircraft. The Beechcraft King Air fleet will support the Kingdom of Saudi Arabia’s National Center for Meteorology program for cloud seeding.

AvMet and its partners Weather Modification International (WMI) and Fargo Jet Center (FJC) will work collaboratively to equip the four King Air 260 aircraft with a Cloud Water Inertial Probe (CWIP), Data Logger with aircraft tracking, and cloud seeding equipment. The King Air 360CHW will be rigged with Cloud Seeding equipment, a research laboratory and an instrument package for studying cloud physics and aerosols.

The aircraft will be modified at WMI’s headquarters in Fargo with sister company Fargo Jet Center LLC (FJC). FJC’s Part 145 Repair Station, which is an authorized service facility for the family of Beechcraft King Air aircraft, teamed with WMI to certify the Federal Aviation Administration approved Supplemental Type Certificate modifications for cloud seeding and atmospheric research equipment. Together, Textron Aviation, WMI and FJC will provide the Kingdom of Saudi Arabia’s National Center for Meteorology with the newest technologies in cloud seeding and atmospheric sciences instrumentation.

Endless Special Mission Possibilities

When government, military and commercial customers want airborne solutions for critical missions, they turn to Textron Aviation. The company’s aviation solutions provide the high performance and flight characteristics required to address the unique challenges of special mission operations. With unparalleled quality, versatility and low operating costs, Textron Aviation products are preferred for air ambulance, ISR, utility transport, aerial survey, flight inspection, training and a number of other special operations.

Boeing to Deliver Additional Chinook Helicopters to U.S. Army Special Operations

November 25, 2021 / WIL BALDWIN

Boeing [NYSE: BA] will build six more MH-47G Block II Chinooks for the U.S. Army Special Operations Aviation Command as part of a $246.48 million contract.

Delivery of these aircraft are scheduled to start in 2023. With this additional order, Boeing is now under contract for 30 MH-47G Block II Chinooks, four of which have been delivered to date.

These aircraft will be the first to include the new Active Parallel Actuator Subsystem (APAS), a mission system that helps pilots execute more difficult maneuvers while improving safety and reliability of flight.

The MH-47G Block II Chinook also features improved structure and weight reduction initiatives like new lighter weight fuel pods that increase performance and efficiency.

Boeing has more than 4,600 Boeing employees in Pennsylvania supporting H-47 Chinook, V-22 Osprey, MH-139A Grey Wolf and a number of services and engineering efforts. Boeing’s presence, including suppliers and vendors, supports an estimated 16,000 total jobs in Pennsylvania.

Alstom Presents First Aptis Serial Vehicle at Busworld 2019

October 14, 2019 / WIL BALDWIN

14 October 2019 – Alstom will present the first serial vehicle of its Aptis electric bus at Busworld 2019, being held in Brussels from 17 to 23 October. After the four prototypes that have been on the roads of many French and European cities for the past two years, this new design incorporates feedback from passengers and transport operators.

This first serial vehicle is based on an optimised global architecture requiring fewer spare parts references and considerably facilitating maintenance operations. Thanks to a wheel steering angle of more than 40°, its ease of insertion increases significantly. The 15% reduction in the total weight of the vehicle, combined with the use of new, more efficient and state of the art batteries, substantially increases range. Aptis now accommodates more passengers while still offering them more fluidity thanks to large sliding doors.

In addition to the technical improvements, Aptis can also boast significant improvements to passenger comfort. A new air-conditioning system that (fully electrical heat-pump) maximises thermal comfort and the panoramic rear lounge has been enhanced to give a feeling of increased space. The new hydraulic suspension allows superior comfort and sound insulation, making Aptis one of the quietest and most innovative buses on the market.

“Alstom and its teams are very proud to be presenting the first series version of Aptis. This concentration of innovations perfectly represents what we always envisaged the production version of the 100% electric mobility solution would be. This clean, green bus, with its elegant design and optimised technical performance, will offer a new experience to passengers and drivers while meeting the new mobility challenges of urban areas,” underlines Benjamin Bailly, head of Alstom’s electric bus platform.

Aptis has already been chosen by Paris in the context of Europe’s largest call for tender for electric buses, as well as by the cities of Strasbourg, Grenoble, La Rochelle and Toulon. Upcoming milestones include ongoing tests in Spain with the ground-based recharge solution SRS and the training of hundreds of drivers in a new driving experience ahead of the first traffic releases, scheduled for the end of the year in Strasbourg.

Manufacturing and testing of Aptis will be carried out at Alstom’s two sites in Alsace. The Hangenbieten site oversees manufacturing of the end modules (driver’s cab and rear lounge). Manufacturing of the central passenger module, final assembly and tests will be carried out at the Reichshoffen site. This scheme will allow serial production from the end of 2019 onwards. Five other Alstom sites in France contribute to the design and manufacture of Aptis: Saint-Ouen for system integration, Tarbes for traction, Ornans for engines, Villeurbanne for electronic components of the traction chain.

In order to complete Alstom’s vison of road electromobility, exhibited alongside Aptis at Busworld will also be SRS, a completely safe, ground-level, conductive, static recharge system allowing the charging of buses along their route or within depots. As a ground-based solution, it eliminates the need for overhead infrastructure in cities, preserving the aesthetics of the urban landscape. In depots, SRS avoids the infrastructure costs associated with overhead charging systems. SRS for e-buses is based on Alstom’s SRS static recharge technology for trams, a proven solution already in operation in Nice, France. It is developed at Alstom’s Vitrolles site.

FAA Investigates Southwest over baggage weight discrepancies

February 18, 2019 / WIL BALDWIN

(Reuters) – The U.S. Federal Aviation Administration is investigating Southwest Airlines Co for widespread failure to accurately track the combined weight of checked bags loaded onto its jets, the Wall Street Journal reported on Monday.

The U.S. aviation safety agency’s year-long civil probe found systemic and significant mistakes with employee calculations and luggage-loading practices, resulting in potential discrepancies when pilots compute takeoff weights, the Journal reported, citing government officials and internal agency documents

The FAA has not decided whether to impose fines or any other punishment, the report cited people familiar with the investigation as saying.

The inaccuracies ranged from a few dozen pounds to more than 1,000 pounds (450 kg) in excess of what the paperwork indicated, sparking disputes between the company and some agency inspectors about potential safety consequences, the report said.

A company spokeswoman said there was an open Letter of Investigation (LOI), which is a common mechanism for the FAA to document and share safety interests or concerns with an airline.

The airline has not been issued fines and faces no enforcement action regarding its weight and balance program, Southwest spokeswoman Brandy King said.

“In this case, the LOI addresses an issue that Southwest voluntarily reported to the FAA last year and since that time, Southwest has implemented controls to address weight and balance program concerns, and shared those measures with the FAA,” King said.

The FAA said in a statement it initiated a probe against Southwest in 2018 regarding weight and balance performance data.

“Since that time, the FAA has directed the development of a comprehensive solution to the methods and processes used by Southwest Airlines to determine this performance data,” it said in the statement. “The FAA will not close its investigation until it is satisfied that Southwest’s corrective actions are consistent and sustained.”

(Reporting by Rama Venkat in Bengaluru; Editing by Bernadette Baum and Peter Cooney)